CalcuPK

Merit and admission aggregate calculators

An admission aggregate applies a university's published weighting to each of your marks: component percentage times weight, summed across components. The weightings differ sharply — medical admissions use 10% Matric, 40% FSc and 50% MDCAT, while NUST uses 75% for its entry test and UAF uses a 30:30:40 split. Always use the formula for the university and admission year you are applying to.

Summary of this calculator's current selection
SectionMerit and admission aggregate calculators
Calculators7
CoveragePakistani universities and admitting authorities
Primary outputLinks to each calculator with its formula
Last verified2026-07-22
Free to useNothing is uploaded — calculations run in your browserEstimate — verify with the official source

How this calculation works

Formula

The two calculations, side by side

 GPA / CGPAMerit / aggregate
Used forCoursework you have completedApplying for admission
InputsCredit hours and gradesMatric, Intermediate and entry-test marks
FormulaQuality points ÷ credit hoursΣ (percentage × weight)
ResultA figure out of 4.00A percentage out of 100

University merit formula comparison

Every weighting below is drawn from CalcuPK's verified preset for that institution, with the policy session and source shown. Academic weight is the combined Matric plus Intermediate share; test weight is the entry-test share.

InstitutionRoute / testAcademicTestSessionSource
MDCATMDCAT50%50%Admission session 2025–26Official
UHS PunjabMDCAT50%50%Admission session 2025–26Official
SindhMDCAT50%50%Admission session 2025–26Official
KPMDCAT50%50%Admission session 2025–26Official
NUMSNUMS MDCAT (entrance test)50%50%Admission session 2025–26Official
NUSTNUST Entry Test (NET)25%75%Admission cycle 2025Official
UET LahoreECAT67%33%Fall 2026 admissionOfficial
UET TaxilaTCAT / ECAT67%33%Fall 2026 admissionOfficial
FASTAdmission test (FAST-NUCES / SAT / NAT-IE)67%33%2026 admission cycleOfficial
FASTAdmission test (FAST-NUCES / SAT / NAT)50%50%2026 admission cycleOfficial
COMSATSNTS NAT test50%50%Current published policy (live pages undated)Official
UAFUAF Entry Test60%40%Winter Semester 2025–26Official

Exceptions: NUMS uses its own 200-mark test; UAF uses a 30:30:40 split; COMSATS Architecture & Design uses a 30/70 creative-aptitude route; UET non-ECAT programmes use 25/75 with no test. See each calculator for the full rules.

Common mistakes

  • Using FSc Part-I and Part-II marks where the university's formula specifies Part-I only, as NUST and UET Lahore do.
  • Entering an entry-test score against the wrong total — MDCAT is out of 180, NUMS out of 200, ECAT out of 400.
  • Checking only the aggregate and missing a hard eligibility floor that disqualifies the application outright.

Key terms

Admission aggregate
A single percentage that combines your Matric, Intermediate and entry-test marks using the weights a university publishes. It is used to rank applicants on a merit list.
GPA
Grade Point Average — total quality points divided by total attempted credit hours for a single semester, on a scale that is usually 4.00.
CGPA
Cumulative Grade Point Average — the same calculation as GPA but across every completed semester, weighted by credit hours.
Closing merit
The aggregate of the last candidate admitted to a programme in a given year. It is set by supply and demand each cycle and is not a fixed pass mark.

Frequently asked questions

It reflects how much each institution trusts board results versus its own test. NUST weights its NET at 75%, so the test dominates. Medical admissions weight MDCAT at 50%. UET Lahore weights ECAT at only 33% and FSc Part-I at 50%. The same candidate can rank very differently at two universities purely because of these weights.